*Eyelet hole on top and bottom for bracelet pendant. *Thick enough to write STRENGTH in all capital letter on upper left edge. But I definitely want to keep it the "S" style. If you have some other creative ideas, I am open to them for this lightning bolt. And a 5 point star engraved in the center of the lightning bolt. I just want a clean "S"- shaped Lightning Bolt. And the bracelet version need to have two holes put at the end of each wing. The Necklace version should have the eyelet hole in the middle of the eagle. I am not good at drawing but I have included some very rough sketches as well as other photos I like. Looking for some fine craftsmanship here. *I would like it as detailed as possible with engravings in the feathers and such. *Logo on back like above (just the compass star wherever it will fit) *The word FREEDOM in all capital letters engraved on edge of pendant (top or bottom edge side of one of the wings) *Same dimensions for eyelet hole as Tree above *Main Pendant: 40mm wide (from wingtip to wingtip) Nicely detailed flying American Bald Eagle Pendant (would like to replicate something just like the attached photo) The head of the eagle does not have to stand out like the pictured photo but if it is possible, I do like that style. And one for the bracelet with an eyelet hole at top and bottom. One for the necklace with just one eyelet hole at top.
*I will need 2 files created for 3D Printing each pendant. I want the circle around the tree to be perfectly round and approximately 1mm thick looking at it from above. *I would like to be able to see through the pendant in spots like the sample picture I attached. When these pendants are casted those little engraved marks turn black in the process and add a lot of character to the end product. And I would like the trunk of the tree to have a couple lines of texture engraved to look like bark. I would like the maple leaves (see attached photo of maple leaves) to have some finely engraved veins if possible. *I would like the Tree to have some dimension and character to it. I am really only concerned with the details on the front. *Backside does not really need to have any detail except the logo. *All I want on the back side (or underside of pendant) is my Logo design (the compass - not the name) Anywhere it will fit on the back side. I am willing to adjust thickness of pendant if needed to fit the word LIFE on edge *The word LIFE in capital letters engraved on the side edge of the pendant. *Metal part of eyelet hole just 1mm thick So you can see through the hole looking at the pendant sideways. And I want the eyelet hole to be perpendicular to the main pendant. *Eyelet hole for chain to go through 3-4mm inside hole width. I've included some very rough sketch drawings too. *I want a nicely detailed Tree with Maple Leaves inside a circle (see attached Tree Pendant photos for reference) I like the style of the pictured pendant but I want a few changes.
0 kommentar(er)
